Well this started as a quick sketch of what I am planning on building in the next few weeks, but I think that with a little work it could look very nice..
So it's a snare drum with an acrylic shell, but not an ordinary one- it is (or will be) made from plate acrylic, cut into wedges and welded together at the seams to make a solid shell. The lugs are offset onto alternating segments. (those are just prototypes I made just to get an idea at the time)
Now about the model. The focus of this render is the snare drum of course; it is missing the snare strainer and the lugs are also incomplete at the time of this rendering. I also didn't set up any lighting so the white drumhead on top appears much darker than it should. Anyways, the other drums and the ride cymbal in the back ground are remnants from a previous attempt at making a drum set, back before I had figured out lathing and the such. It's all floating drums right now. I eventually want to complete the entire kit, including hardware. Maybe even animate it if I have the time (and patience with the camera. I'm horrible at operating it like I want. And also the undo buttons not doing what I think they should in scene mode. If I move an object or rotate it on accident, I WANT IT TO BE UNDONE WHEN I HIT UNDO!!!)
From the improvements side of things, I really wanna see what the bearing edges will look like once I cut them with a router. For non-drummer folk, bearing edges are the top and bottom of the shell where it comes in contact with the drumhead, usually cut to a 45 degree angle on both sides forming a 90 degree angle on top. My situation is unique however, since the shell is not "round" (I say round in quotes on the basis that nothing is truly round in 3D programs, just lots of segments). 45 degree angles cut from "circle" of where the drum contacts the drum head will result in varying heights of cut on the edge. For example, its like sharpening one of those pencils with the six sides- cone shape from the point comes down at a continuous angle, but differences in radius make a wavy-looking cut. Any help modeling this without tons of point editing would be greatly appreciated.
Any other C&C welcome too.