1
Finished Works and Works in Progress / Re: My werewolf
« on: March 22, 2008, 07:38:04 pm »
Looks pretty good.
The seam down the middle is a pretty easy fix.
-Select both halves of the werewolf (i'm guessing it's in two parts)
-Build=>Join Solids
-Select all the points down the middle
-Do a Non-Uniform Scale (hotkey N) on only the X axis (so press Y and Z to disable these) so that the points in the middle are an infinitesimal distance apart
-Hit Shift+L to merge those points. If the step above worked well, you could change the distance from .5 to like .1 or even lower
That should do it.
This method is a good way to create symmetrical models without shaping both sides at the same time. You just model half, then mirror it, then follow the steps above. It could have saved you quite a bit of work!
The seam down the middle is a pretty easy fix.
-Select both halves of the werewolf (i'm guessing it's in two parts)
-Build=>Join Solids
-Select all the points down the middle
-Do a Non-Uniform Scale (hotkey N) on only the X axis (so press Y and Z to disable these) so that the points in the middle are an infinitesimal distance apart
-Hit Shift+L to merge those points. If the step above worked well, you could change the distance from .5 to like .1 or even lower
That should do it.
This method is a good way to create symmetrical models without shaping both sides at the same time. You just model half, then mirror it, then follow the steps above. It could have saved you quite a bit of work!
