Anim8or Community

General Category => Anim8or v1.0 Discussion Forum => Topic started by: itsstillthinking on March 22, 2018, 02:46:15 pm

Title: Scanline Limits?
Post by: itsstillthinking on March 22, 2018, 02:46:15 pm

Made another post about this elsewhere but thought it more relevant here
So does anyone know if there is a limit to rendering in scanlines? iv tried all sorts of settings (as seen by the test below) but it always seems to crash after rendering 100 frames or so. Any ideas on ways to fix this? tried to keep the z near to 10 and the z far to 10000

Title: Re: Scanline Limits?
Post by: itsstillthinking on March 22, 2018, 08:50:30 pm

Ohhhhhh i think i figured it out, like a moron i set the z near to 10, so its trying to render close to the camera where i dont care about that so i should have set it to a larger number :-*