Anim8or Community

General Category => General Anim8or Forum => Topic started by: argo34116 on April 11, 2016, 09:47:57 pm

Title: Trouble with fragmented top hull text
Post by: argo34116 on April 11, 2016, 09:47:57 pm

I have a model of the Uss Equinox. It is good except that the text that appears on the top and bottom saucer sections is fragmented (see attached image). I have also included the model and textures here for you all to examine. Thank you.

Title: Re: Trouble with fragmented top hull text
Post by: argo34116 on April 14, 2016, 01:42:40 am

I cannot upload the mesh so here is the link for it.
http://www.trekmeshes.ch/

Title: Re: Trouble with fragmented top hull text
Post by: kreator on April 14, 2016, 02:22:22 am

The Lettering is only fragmented as it has sunken into the hull. You need to pull each letter out then it will be all right The logos etc are all objects and not part of the textures. The S N and O in USS Equinox I have not pulled out in the screenshot, where there are red flashes theses would need to be pulled out also

Title: Re: Trouble with fragmented top hull text
Post by: argo34116 on April 15, 2016, 02:10:57 am

How do I do that?

Title: Re: Trouble with fragmented top hull text
Post by: kreator on April 15, 2016, 04:45:59 am

Go into point mode, Have points selected, Click a Point in the letter then hit c key (This selects all the points in the letter)then you can lift it with the up arrow key. (TBH, you really should do some modelling instead of grabbing ready made models, then you might learn something!)

Title: Re: Trouble with fragmented top hull text
Post by: johnar on April 15, 2016, 08:33:11 am

Quote

Click a Point in the letter then hit c key (This selects all the points in the letter).

Nice one kreator (http://s6.postimg.org/p4cqdev8d/grysmile.gif)