Anim8or Community

General Category => Anim8or v0.98 Discussion Forum => Topic started by: odp04y on February 25, 2009, 11:27:17 am

Title: 3 views bug
Post by: odp04y on February 25, 2009, 11:27:17 am

I don't think this has been mentioned before.

In 3 view viewport, if you try to change one of the views (with numpad or by selecting from top left corner) it goes back to one viewport mode.

Title: Re: 3 views bug
Post by: neirao on February 25, 2009, 01:33:32 pm

is true, i saw this bug too...

Title: Re: 3 views bug
Post by: Dreadkb on February 25, 2009, 11:19:31 pm

Happens to me in every multi view except 4 way view

Title: Re: 3 views bug
Post by: Steve on March 03, 2009, 01:51:55 am

Yup.  Looking at this now.  #097-026 - Selecting Menu->ViewX Reverts 2 and 3 view mode to 1 view.

Title: Re: 3 views bug
Post by: Steve on March 05, 2009, 01:02:14 am

I have a fix that will be in the next preview/release.  Thanks for reporting this, odp04y.

Title: Re: 3 views bug
Post by: $imon on March 05, 2009, 03:16:05 am

Yes good point!

On about the same note - thought it would be wasteful to open a new thread.. When changing from a 4 view viewport to a 1 view viewport (not sure about the other way around) the 'mode' of the view changed, so from a wireframe view > solid wire, while the button is still on the wireframe view.

Does anyone else have this sometimes?

Title: Re: 3 views bug
Post by: Tanzim on March 06, 2009, 01:55:26 am

Yes, I have that problem as well when using Anim8or, usually after rendering, although I haven't been having it as often recently.

Title: Re: 3 views bug
Post by: xalener on March 06, 2009, 07:46:01 pm

Also, sometimes when you click the "full view button" It just zooms out.