Anim8or Community

General Category => Anim8or v0.98 Discussion Forum => Topic started by: hihosilver on February 05, 2009, 01:03:57 am

Title: Spin Edge Request
Post by: hihosilver on February 05, 2009, 01:03:57 am

I believe a "spin edge" command would be wonderful for Anim8or.  Perhaps this could be implemented with a script, but would be much easier to use if there were some kind of keyboard shortcut.
Here is an example of the command in Silo (http://www.nevercenter.com/wiki/index.php?title=Spin_Edge).
The tool is very useful for quickly altering polygon flow without having to delete and edge then rebuild it and fill holes again.

Thanks for your consideration.

Title: Re: Spin Edge Request
Post by: Claude on February 08, 2009, 11:49:09 pm

Nothing I can do about the keyboard shortcut,but
a script is possible.
Ready to give it a road test ?

Title: Re: Spin Edge Request
Post by: hihosilver on February 09, 2009, 10:49:10 pm

Woo!  Awesome, well I haven't found any issue with it yet!  Haven't done extraneous testing, but it looks good.
If it could be implemented into Anim8or, that would be great, just because of the quickness of shortcuts.  Still, thanks a ton Claude, this will be useful!

Title: Re: Spin Edge Request
Post by: Claude on February 10, 2009, 03:46:27 pm

Welcome

Title: Re: Spin Edge Request
Post by: Steve on February 12, 2009, 01:21:17 am

"Spin quads" will be in the next preview.  It's the same as spin edge for edges between two quads.  Lightwave has it and it's a very useful modeling tool.

Title: Re: Spin Edge Request
Post by: Tanzim on February 12, 2009, 04:10:49 am

Sounds interesting, thanks Steve.

Title: Re: Spin Edge Request
Post by: hihosilver on February 12, 2009, 07:20:23 pm

Awesome, thanks Steve